Control cable acid and alkali resistant, resistant to hydrolysis, anti-ultraviolet radiation, low temperature resistance, wear resistant, flame retardant CC46 bending radius: soft cable are different from common fixed gear cable, device, please refer to the following device and the matters needing attention: drag chain cable laying cannot distort, i.e., not from the cable reel or cable one end unlock cable, and should be rotating drum or cable to cable expansion and, when necessary, will cable deployment or hang up. For the occasion of the cable can only be achieved directly from the cable volume, must pay attention that the minimum bending radius of cable. Cable must be loose laying side by side in tow chain, as separate arrangement, with spacer separate or wear into the separation of neutral stand empty, tow chain in the gap between cable should be at least 10% of the cable diameter drag chain of cable shall not touch each other or stuck together. Cable two points must be fixed, or at least in tow chain movement end must be fixed. The general cable mobile point from tow chain end distance should be cable diameter twenty - 30 times. Please ensure that the cable in the bending radius move completely, that is not forced to move. This cable mutual or and guide this by relative movement. After a period of time after the operation, it is best to check the position of the cable. This check must be in push-pull after moving. If the drag chain break, the cable also need to change, because excessive tensile damage caused by not prevent.

According to modern enterprise system building of wire and cable manufacturing enterprise. The main products are installed wiring wire cable, control cable, power cable, elevator cable, preliminary branch cable, rubber sleeve cable, mine fire retardant communication cable, control cable, mine mining signal cable, local communication cable professional manufacturers, copper clad aluminum conductor cable, etc.